抗氢致开裂HIC试验报告模板

检测报告Test Report报告编号Report No.样品名称Sample Name委托单位Entrustment Company试验项目Test抗氢致开裂试验HICProjectResistance toHydrogen-Induced CrackingTest型号/规格样品名称钢管60*10Sampel NameSteel PipeModel andSpecification生产商产品批号/12003Manufacturer NameProduct orLot No.材质及状态炉批号20#694587Material andCondition HeatBatch Number样品数量Ipc样品编号Sample quantitySample No./购买商Buyer委托单位Entrustment Company委托单位地址EntrustmentCompany Address样品接收日期Sample ReceivedDate测试周期Test Period抗氢致开裂试验测试项目HICTest ProjectResistance toHydrogen-Induced CrackingTest测试标准GB/T8650-2015Test standard测试结果CLR=

3.43%,CTR=

1.02%,CSR=

0.01%Test Results要求CLR10%,CTR3%,CSR1%Requirement结论符合Conclusion Pass备注要求由客户规定Remark Requirementsare specifiedby client.检验检测专用章编制审核签发Compiler:________________Auditor:________________Certifier:日期日期日期:Date:________________Date:___________________Date:Inspection andTesting SpecialSeal For测试项目抗氢致开裂试验HICTest Project:Resistance toHydrogen-Induced CrackingTest测试设备金相显微镜JC-001Nikon EP300+DS-5M-L1校准日期:Test Equipment:JC-OO1metallurgical microscopeNikon EP300+DS-5M-L12021-10-30Calibration Date:2021-10-30测试环境

22.6℃/41%RHTest environment:

22.6℃/41%RH测试步骤和条件Test stepsand conditions:脱氧气体测试气体测试时间八八

99.995%N

299.95%H SDeoxygenatedgas296hTest GasTestPeriod溶液脱脂方式丙酮+酒精清洗A测试溶液/Test solutionAsolution Degreasemethod Acetone+Alcohol cleaning饱和后溶液的H SpH pH of2初始溶液pH

2.75the H2s SaturatedSolution

2.79pH of the InitialSolution饱和H S溶液的H S含量mg/L试验后溶液pH pH of Test22H2s Concentrationof H2s SaturatedSolution2520Solution atEnd ofthe Test

3.87取样位置和取样方向沿纵向取样Orientation andPosition Alongwith longitudinal注、溶液是质量分数为氯化钠及冰乙酸的蒸储水溶液；1A5%

0.50%、试验过程为制备试样；放入试验容器；配制溶液；测初始溶液的；21234pH以的速度通氮气除氧两个小时；5100ml/min/L以的速度通入至少小时至溶液饱和；6200ml/min/L H2s1测饱和溶液的值和的含量；7H SpH HS22维持正压至测试结束；8H2s测试终止时溶液的值；9pH测试结果检验10Note:

1.Solution Ashall be

5.0wt%NaCl and

0.50wt%CH3COOH indistilled water.

2.Test procedure:1Preparation ofspecimen;2Test specimensshall beplaced inthe testvessel3Solution preparation;4Measure thepHofinitial solution5Purge the test solutionwith nitrogenfor at least twohours at a rate of100ml/min perliter of testsolution.6H2s gasshall bebubbled throughthetest solution fdratleastone houratarateof200ml/min perliteroftestsolution.7Measure thepH andH2s concentrationof H2s saturatedsolution.8Maintain H2s positivepressure untilthe end oftheexperiment.9Measure thepHoftestsolutionat theendoftest.10Examine thetest specimensafter testing.测试结果:Test Results:试样编号检测面CLR%CTR%CSR%Test实测每个试样每组试样实测每个试样每组试样实测每个试样每组试样Sample NoSurface值平均值值Test平均值，值平均值平均值Test平均值Test Average平均值Value AverageAverageAverage ValueAverageValue Value of AverageValue of Value ofValueofValueofEach TestValueofEach TestEach TestEachGroup EachGroupSpecimen EachGroup SpecimenSpecimen01-

15.

900.

720.04JC

220927007.

112.

680.2301-

26.

220.

920.0611-101-

39.

196.

400.5902-

15.

070.

490.02JC

220927001.

693.

430.

161.

020.

010.0802-200011-202-300003-1000JC

220927001.

490.

230.0103-

24.

460.

700.0311-303-3000E ff1lI产.「温s^S------1■「■A M___Be皿皿皿啦皿皿||她皿|||||皿皿|皿||||||||||皿|||||皿［||||皿皿血^^^^测试前测试后Before testAftertest***报告结束*****End ofreport***。